Thursday, 3 March 2011


















Using the symetry in modify list I finished my wheel. Later I just changed the colour of the rim and inside of the wheel.



I used bevel tool to extrude the cylinder and make the end of it narrowed.









I used insert tool and bevel tool to create these shapes. All was in editable poly.

I turned the wheel and bridged the edges as it is seen on the picture. I used vertex mode for selecting lines.








Then, I made the circle in the middle with insert tool as well and triangles holding shift. I used polygon mode for that and with selection tool extruded it down.
With polygone mode I have chosen the area and then pressing insert and changing the amount of it I made a shape of the wheel.












I created a cylinder, converted it to editable poly and using polygon mode delited hald of it.













I have made all the siluet of the car following the technique holding shift and extruding from previous polygon. To make the place for the lights I had to connect some lines ( selecting lines with edge mode and pressing connect) to have more points which later I had to moove reaching the shape. It was made using editable poly's vertex mode.
My second model is Aston Martin.


I have made 3 planes with top, side and front views of the car, but later I found that my top view is not very good so I had to create my model only with front and side views gessing the gabarits of the car. I imported the pictures through bitmap and applyed to the planes freezing them that they don't moove.
I started my model with tube creation where I deleted lower half of it. Later, choosing edge mode from editable poly and pressing shift I extrudeded every squere of the tube and looking to all the views of the car made sure I place the squeres on the correct position. Also vertex mode was usede a lot to put some points to the right place.