Friday, 4 March 2011


The propeller.














First of all, I have created a cylinder as a main body. Then converted it to editable poly and using polygon mode selected the top of cylinder. After all these, using Inset and bevel I made the shape which is shown on the picture.

Thursday, 3 March 2011























Using the edge mode from editable poly I have selected the lines where the window should be and clicked create shapes from selection. Also I changed selection filter to shapes. When I had the line I have created I coppied it twice placing one in the moddle and another at the end.
I attached all three lines and going to modify panel selected cross section.
Then, selecting created cross section on modify panel I selected surface and the window appeared.
Some front windows were made from boxes it is faster and easier.

Converting the plane to editable poly and using edge mode I selected some lines and clicked connect. These helped to make more lines and later using vertex mode to have more points. Then, I mooved the points creating the shape of windows and made holes.

Another pyramid was created and added to the ending of the plane. The shape was changed by select and uniform scale but also a little bit using tools from editable poly.



The wings were created from pyramid figure converting it to editable poly and changing the shape with selection tools. There is another small pyramid on the end of the wing.











My last model is an airplane.



I made a cylinder and using bevel tool in editable poly I extruded it narrowing till the end.


Finished Aston Martin






















To make the lights I used border mode selecting the edge and selecting cap I have closed the hole with material. Later I edded 2 cylinders which are the actual lights. The back lights were made with tubes.


I made car windows using edge mode from editable poly to select the lines (loop). Then clicked Create shapes from selection and in selection filter I have chosen Shapes. Later I cloned the figure and placed it in the middle of windscreen. I did the same again and placed another figure where the end of the window is. I had to attach all of them clicking right click of the mouse (attach) and going to modify panel I have chosen cross section so it appeared on the attached lines. After, in the same modify list Surface was selected and it apeared as a windscreen.