To make the lights I used border mode selecting the edge and selecting cap I have closed the hole with material. Later I edded 2 cylinders which are the actual lights. The back lights were made with tubes.


I made car windows using edge mode from editable poly to select the lines (loop). Then clicked Create shapes from selection and in selection filter I have chosen Shapes. Later I cloned the figure and placed it in the middle of windscreen. I did the same again and placed another figure where the end of the window is. I had to attach all of them clicking right click of the mouse (attach) and going to modify panel I have chosen cross section so it appeared on the attached lines. After, in the same modify list Surface was selected and it apeared as a windscreen.