Thursday, 3 March 2011

My second model is Aston Martin.


I have made 3 planes with top, side and front views of the car, but later I found that my top view is not very good so I had to create my model only with front and side views gessing the gabarits of the car. I imported the pictures through bitmap and applyed to the planes freezing them that they don't moove.
I started my model with tube creation where I deleted lower half of it. Later, choosing edge mode from editable poly and pressing shift I extrudeded every squere of the tube and looking to all the views of the car made sure I place the squeres on the correct position. Also vertex mode was usede a lot to put some points to the right place.

No comments:

Post a Comment